Uncoiler
Production Description
Un-Coler is the important eauipment of entrance secton oft pipe mi ine. Mainiv used to hod stee strin to make coils untoid. Supplying raw material for the production line .
Classification
1.Double Mandrels Uncoiler
Two mandrels to prepare two coils, automatic rotating, expanding shrinking/braking using a pneumatic controlled device, with piess roller and side arm to prevent coil loosening and turning over.
2.Single Mandrel Uncoiler
Single Mandre to load heavier coils, hydraulic expanding/shrinking, with press roler to prevent coil loosening, comes with a coil car to help coil loading.
3.Double Cone Uncoiler by hydraulic
For heavy coils with a large width and diameter, double cones, with coil car, automatic coil up-loading and centering
Advantages
1. High Precision
2. High Production efficiency,Line speed can be up to 130m/min
3. High Strength,The machine works stably at a high speed, which improves product quality.
4. High Good product rate, reach to 99%
5. Low wastage, Low unit wastage and low production cost.
6. 100% interchangeability of the same parts of the same equipment
Related products
-
Shear and end welding machine
Production Description The shear and end welding machine is used for shearing the strip head from the uncoiler and strip end from accumulator and then welding the head and tail of strips together This equipment permits to continue the production without feeding the line for the first time for every coils used. Together with the accumulator, it permits to change coil and joint it with the already working strip maintaining constant the speed of...
-
Tool holder
Tool holders are supplied with their own fixing system which utilises a screw, stirrup and carbide mounting plate. Tool holders are supplied as either 90° or 75° inclination, depending on your mounting fixture of the tube mill, the difference can be seen in the photos below. The tool holder shank dimensions are also normally standard at 20mm x 20mm, or 25mm x 25mm (for 15mm & 19mm inserts). For 25mm inserts, the shank is 32mm x 32mm, this size is also available f...
-
flying saw
Production Description COLD DISK SAW CUTTING MACHINE (HSS AND TCT BLADES)This flying saw is able to cut tubes with speed set up to 160 m/min and the tube length accuracy up to +-1.5mm. An automatic control system allows to optimize blade positioning according to the tube diameter and thickness,setting the speed of feeding and rotation of the blades. This system is able to optimize and increase the number of cuts. The benefit Thank to milling...
-
Milling type orbit double blade cutting saw
The description Milling type orbit double blade cutting saw is designed for the in-line cutting of welded pipes with larger diameters and larger wall thicknesses in round ,square&rectangular shape with speed up to 55m/minute and the tube length accuracy up to +-1.5mm. The two saw blades are located on the same rotating disc and cut the steel pipe in R-θ control mode. the two symmetrically arranged saw blades move in a relatively straight line along the radia...
-
Outside Scarfing Inserts
SANSO Consumables offers a range of equipment and consumables for scarfing. This encompasses Canticut ID scarfing systems, Duratrim edge conditioning units and a full range of high quality scarfing inserts and associated tooling. OD SCARFING INSERTS Outside Scarfing Inserts OD scarfing inserts are offered In a full range of standard sizes (15mm/19mm & 25mm) with positive and negative cutting edges
-
ERW219 welded pipe mill
Production Description The forming fundamental of ERW tube mill The forming fundamental of tube mill: the slit strip is formed into approximate round steel tube without welding by the forming mill,and then the tube’s edge is melted and welded by the HF induction welder and the welded seam is squeezed Immediately after welding at welding section of tube mill .At this stage, the steel pipe welding is completed, the welded tube through cooling ...